explained this photo lower down.
here we are making room for the hardwear we drilled the big hole with a 54mm hole borer and drilled the smaller hole with a 22mm drill bit, it was 900mm off the ground. when drilling we had another person watching to make sure that we where drilling square, some people also took the doors off and put them on sore horses and drilled the holes out that way.
we then had to chisel out a bit for the lock to fit in we had to be very careful doing this as if you went to close to the edge it would break,
when i was fixing the keep i misplaced it and had to rebog it as it was hanging to far over it now looks alot better.
Good photos James, supported by some explanations
ReplyDelete