over all i am proud of the work i have done on this house i have learnt alot and have got confused at times to, i hope to over the next few years gain lots more skills, and hope to one day build my own house, i am looking forward to getting out and gaining lots more knowledge and getting some hours.
building
Tuesday, May 31, 2011
finishing lines
skirting, when we did our finishing lines we would measure up then go cut a 45 degree angle out of one end, then cut most the way up that 45 degree angle with a 90 degree angle then we would get a hack saw and cut all the way up the cut until we we mm from the edge of the cut, this would leave us with a small triangle at the top, this allows movement in the house and stops cracking in paint work. it almost looks like two 45degree angles meeting.
doors
explained this photo lower down.
here we are making room for the hardwear we drilled the big hole with a 54mm hole borer and drilled the smaller hole with a 22mm drill bit, it was 900mm off the ground. when drilling we had another person watching to make sure that we where drilling square, some people also took the doors off and put them on sore horses and drilled the holes out that way.
we then had to chisel out a bit for the lock to fit in we had to be very careful doing this as if you went to close to the edge it would break,
when i was fixing the keep i misplaced it and had to rebog it as it was hanging to far over it now looks alot better.
here we are making room for the hardwear we drilled the big hole with a 54mm hole borer and drilled the smaller hole with a 22mm drill bit, it was 900mm off the ground. when drilling we had another person watching to make sure that we where drilling square, some people also took the doors off and put them on sore horses and drilled the holes out that way.
we then had to chisel out a bit for the lock to fit in we had to be very careful doing this as if you went to close to the edge it would break,
when i was fixing the keep i misplaced it and had to rebog it as it was hanging to far over it now looks alot better.
carrying and storing GIB
in this photos it shows how we stacked and carried our gib, we would always lift with two or more people as some of the gib especial the aqualine was very heavy, we stacked it in lengths and layed it evenly across the floor so that the floor wouldn't sink in places, it was also a nice dry spot to store the GIB board
John and myself working on our room
we fixed standard GIB all around the room except for the corner, in the corner we used braceline GIB this has a stronger core and is fixed every 50mm in the corners then 150mm from then on round the edges with clout pins/ gib pins.
the wardrobe
to get the piece of gib in the back of the wardrobe we had to cut down the back of the gib and fold it into the back of the wardrobe then open it out, this is what it ended up looking like
the wardrobe
to get the piece of gib in the back of the wardrobe we had to cut down the back of the gib and fold it into the back of the wardrobe then open it out, this is what it ended up looking like
fixing gib board to walls
here it shows 3 extra blocks fixed to studs to pull the gib in tight to the gorilla grip glue, this stops the gib from bowing out in future.
gibing around doors
first we fixed the piece of gib to the wall and over the door, we then went behind the gib and cut from the back down each side of the door way, we then cut it at the top, finished product as above.
Subscribe to:
Posts (Atom)